JapanCertのCiscoの351-001の試験問題と解答はあなたが受験する前にすべての必要とした準備資料を提供しています。Ciscoの351-001の認証試験について、あなたは異なるサイトや書籍で色々な問題を見つけることができます。しかし、ロジックが接続されているかどうかはキーです。JapanCertの問題と解答は初めに試験を受けるあなたが気楽に成功することを助けるだけではなく、あなたの貴重な時間を節約することもできます。
偉大な事業を実現するために信心を持つ必要があります。あなたは自分の知識レベルを疑っていて試験の準備をする前に詰め込み勉強しているときに、自分がどうやって試験に受かることを確保するかを考えましたか。心配しないでください。JapanCertはあなたがCiscoの351-001認定試験に合格する確保です。JapanCert のトレーニング試験は問題と解答に含まれています。しかも１００パーセントの合格率を保証できます。JapanCertのCiscoの351-001試験トレーニング資料を手に入れたら、あなたは自分の第一歩を進めることができます。試験に合格してから、あなたのキャリアは美しい時期を迎えるようになります。
試験番号：351-001問題集
試験科目：Cisco 「CCIE Routing and Switching Written」
最近更新時間：2013-10-23
問題と解答：238
JapanCert Ciscoの351-001試験問題集は完全な無制限のダンプが含まれていますから、JapanCertを利用したら気楽に試験に受かることができます。製品検定合格の証明書あるいは他の人気がある身分検定によって、JapanCert Ciscoの351-001試験トレーニング資料の長所を完璧に見せることができます。依頼だけでなく、指導のことも最高です。JapanCert Ciscoの351-001試験トレーニング資料に含まれている問題と解答を利用して、Ciscoの351-001認定試験に合格することができます。
JapanCert のCiscoの351-001問題集はシラバスに従って、それに351-001認定試験の実際に従って、あなたがもっとも短い時間で最高かつ最新の情報をもらえるように、弊社はトレーニング資料を常にアップグレードしています。弊社の351-001のトレーニング資料を買ったら、一年間の無料更新サービスを差し上げます。もっと長い時間をもらって試験を準備したいのなら、あなたがいつでもサブスクリプションの期間を伸びることができます。
購入前にお試し,私たちの試験の質問と回答のいずれかの無料サンプルをダウンロード：http://www.japancert.com/351-001.html
NO.1 Refer to the exhibit.
Which switching feature is being tested?
A. loop guard
B. PortFast
C. root guard
D. BDPU guard
Answer: A
Cisco 351-001認定証 351-001
NO.2 Which standard supports multiple instances of spanning tree?
A. 802.1D
B. 802.1s
C. 802.1w
D. 802.1z
Answer: B
Cisco問題集 351-001認定試験 351-001認定資格 351-001参考書
NO.3 Loop guard and UniDirectional Link Detection both protect against Layer 2 STP loops. In which two
ways does loop guard differ from UDLD in loop detection and prevention? (Choose two)
A. Loop guard can be used with root guard simultaneously on the same port on the same VLAN while
UDLD cannot.
B. UDLD protects against STP failures caused by cabling problems that create one-way links.
C. Loop guard detects and protects against duplicate packets being received and transmitted on different
ports.
D. UDLD protects against unidirectional cabling problems on copper and fiber media.
E. Loop guard protects against STP failures caused by problems that result in the loss of BPDUs from a
designated switch port
Answer: BE
Cisco 351-001 351-001練習問題
NO.4 Why does RSTP have a better convergence time than 802.1D?
A. It is newer
B. It has smaller timers
C. It has less overhead
D. It is not timer-based
Answer: D
Cisco練習問題 351-001認定試験 351-001 351-001認証試験 351-001認証試験
NO.5 If a port configured with STP loop guard stops receiving BPDUs, the port will be put into which state?
A. learning state
B. listening state
C. forwarding state
D. loop-inconsistent state
Answer: D
Cisco 351-001参考書 351-001認証試験 351-001過去問
NO.6 Spanning Tree Protocol IEEE 802.1s defines the ability to deploy which of these?
A. one global STP instance for all VLANs
B. one STP instance for each VLAN
C. one STP instance per set of VLANs
D. one STP instance per set of bridges
Answer: C
Cisco練習問題 351-001認定証 351-001問題集 351-001参考書
NO.7 As a network administrator, can you tell me what the root guard feature provides in a bridged network?
A. It ensures that BPDUs sent by the root bridge are forwarded in a timely manner
B. It enforces the root bridge placement in the network
C. It ensures that all ports receiving BPDUs from the root bridge are in the forwarding state.
D. It ensures that the bridge is elected as Root Bridge in the network.
Answer: B
Cisco 351-001認定試験 351-001 351-001認定証
NO.8 Which two of these are used in the selection of a root bridge in a network utilizing Spanning Tree
Protocol IEEE 802.1D.? (Choose two)
A. Designated Root Cost
B. bridge ID priority
C. max age
D. bridge ID MAC address
E. Designated Root Priority
F. forward delay
Answer: BD
Cisco参考書 351-001 351-001練習問題 351-001練習問題
NO.9 The classic Spanning Tree Protocol (802.1D 1998) uses which sequence of variables to determine the
best received BPDU?
A. 1) lowest root bridge id,
2) lowest sender bridge id,
3) lowest port id,
4) lowest root path cost
B. 1) lowest root path cost,
2) lowest root bridge id,
3) lowest sender bridge id,
4) lowest sender port id
C. 1) lowest root bridge id,
2) lowest sender bridge id,
3) lowest root path cost
4) lowest sender port id
D. 1) lowest root bridge id,
2) lowest root path cost,
3) lowest sender bridge id,
4) lowest sender port id
Answer: D
Cisco認定資格 351-001 351-001認定試験 351-001
NO.10 Which three port states are used by RSTP 802.1w? (Choose three.)
A. Listening
B. Learning
C. Forwarding
D. Blocking
E. Discarding
F. Disabled
Answer: BCE
Cisco認定証 351-001 351-001認定試験
NO.11 Spanning Tree Protocol calculates path cost based on which of these?
A. interface bandwidth
B. interface delay
C. interface bandwidth and delay
D. hop count
E. bridge priority
Answer: A
Cisco過去問 351-001認定資格 351-001認定証 351-001認定証 351-001 351-001
NO.12 You have done a partial migration from 802.1D STP to 802.1w STP. Which of the following is true?
A. 802.1D and 802.1w interoperate only when the 802.1D STP domain supports rapid convergence.
B. Ports leading to 802.1D devices will run in compatibility mode, while the rest of the ports will run in
802.1w mode.
C. This is an invalid configuration and a partial migration cannot be done.
D. The bridge timers will be set to match the 802.1D devices.
E. A secondary root bridge will always be populated within the 802.1D domain.
F. If the root bridge is selected within the 802.1D domain, the whole STP domain will run in 802.1D
compatibility mode.
G. In partially migrated 802.1w networks, it is recommended to keep the STP diameter below 4.
Answer: B
Cisco 351-001参考書 351-001 351-001問題集 351-001認定試験
NO.13 What two features in Cisco switches help prevent Layer 2 loops? (Choose two)
A. UniDirectional Link Detection
B. Hot Standby Router Protocol
C. Virtual Router Redundancy Protocol
D. PortFast
E. Root guard
F. Loop guard
Answer: AF
Cisco過去問 351-001過去問 351-001認定試験 351-001練習問題
NO.14 Under which two circumstances would an RSTP bridge flush its CAM table? (Choose two)
A. Upon a port state change
B. Upon receiving a topology change notification
C. When transitioning from discarding to forwarding
D. When transitioning from forwarding to discarding
E. Only when changing from listening to discarding
F. When CAM resources have been completely used up
Answer: BC
Cisco参考書 351-001練習問題 351-001 351-001 351-001
NO.15 When STP UplinkFast is enabled on a switch utilizing the default bridge priority, what will the new bridge
priority be changed to?
A. 8192
B. 16384
C. 49152
D. 65535
Answer: C
Cisco問題集 351-001 351-001参考書 351-001問題集 351-001認定試験
NO.16 What is the purpose of the STP PortFast BPDU guard feature?
A. enforce the placement of the root bridge in the network
B. ensure that a port is transitioned to a forwarding state quickly if a BPDU is received
C. enforce the borders of an STP domain
D. ensure that any BPDUs received are forwarded into the STP domain
Answer: C
Cisco 351-001 351-001 351-001
NO.17 Prior to 802.1w, Cisco implemented a number of proprietary enhancements to 802.1D to improve
convergence in a Layer 2 network. Which statement is correct?
A. Only UplinkFast and BackboneFast are specified in 802.1w; PortFast must be manually configured.
B. Only PortFast is specified in 802.1w; UplinkFast and BackboneFast must be manually configured.
C. None of the proprietary Cisco enhancements are specified in 802.1w.
D. PortFast, UplinkFast, and BackboneFast are specified in 802.1w.
Answer: D
Cisco参考書 351-001参考書 351-001認定資格 351-001参考書
NO.18 Refer to the exhibit.
In the diagram, the switches are running IEEE 802.1s MST. Which ports are in the MST blocking state?
A. GE-1/2 and GE-2/1
B. GE-1/1 and GE-2/2
C. GE-3/2 and GE-4/1
D. no ports are in the blocking state
E. There is not enough information to determine which ports are in the blocking state.
Answer: D
Cisco 351-001問題集 351-001練習問題 351-001 351-001 351-001
NO.19 Refer to the exhibit.
In the diagram, the switches are running IEEE 802.1w RSPT.
On which ports should root guard be enabled in order to facilitate deterministic root bridge election under
normal and failure scenarios?
A. GE-3/1, GE-3/2
B. FE-2/1, FE-3/2
C. GE-1/1.GE-1/2
D. GE-4/1, GE-4/2
E. GE-2/1, GE-2/2
F. GE-3/1, GE-3/2, GE-4/1, GE-4/2, FE-2/1, FE-3/2
Answer: F
Cisco問題集 351-001 351-001認証試験
NO.20 Which of these correctly identifies a difference between the way BPDUs are handled by 802.1w and
802.1D?
A. 802.1D bridges do not relay BPDUs.
B. 802.1w bridges do not relay BPDUs.
C. 802.1D bridges only relay BPDUs received from the root.
D. 802.1w bridges only relay BPDUs received from the root.
Answer: C
Cisco練習問題 351-001認定試験 351-001認定資格
JapanCertは最新の70-688問題集と高品質のLOT-442問題と回答を提供します。JapanCertの000-781 VCEテストエンジンと1Z0-466試験ガイドはあなたが一回で試験に合格するのを助けることができます。高品質のACMA_6.1 PDFトレーニング教材は、あなたがより迅速かつ簡単に試験に合格することを100％保証します。試験に合格して認証資格を取るのはそのような簡単なことです。
没有评论:
发表评论